© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197
| support@rgblink.com | www.rgblink.com
Views Auto Loop refers to the cyclic switching of saved views, allowing users to check multiple
screens simultaneously.
Enable the function to set the loop time between views. For example, if the loop time is set to 10
seconds, each view will be displayed for 10 seconds before automatically switching to the next
view in a loop. After looping the last view, it will automatically jump to the first view and continue
the loop.
3.14.6 Switch Mode
Rotate ENTER knob to move the cursor to【Switch Mode】, press knob once again to enter the
following interface.
mini-edge provides T-Bar PVW mode (default) and CUT mode. Select the mode you want and
customize switch time as needed.
For some important occasions, users might need to preview and preset the next scene to ensure
To Next Page
Loading...
Need help?
General