NOTE:
In order to release the tension of the transfer belt during
transportation, the Transfer Belt Release Wedges are installed
on the front and rear belt tension roller bearing holders. Please
do not forget to remove the wedges at installation of the machine.
To remove the wedge, push the wedge toward the bearing holder
and slide it inside slightly.
25. Confirm the belt bias roller [A] is in the release position (innermost
position) as shown. If not, turn the shaft [B] with a flat head screwdriver
until the belt bias roller comes to the release position.
NOTE:
If the belt bias roller is not in the release position, it will touch the
drum and damage it.
26. Re-install the following units or parts in the following order.
1) Transfer belt unit.
2) Transfer belt cleaning unit
NOTE:
To prevent the lubricant bar from being scratched, pull the
handle of the transfer belt unit slightly to the right while you
re-install the transfer belt cleaning unit.
3) Transfer belt stay (5 screws)
4) Four connectors (6P white, 3P red, 3P white, 3P blue)
NOTE:
The 2P white connector is not used.
5) Toner collection duct (1 hook)
[A]
[B]
Rev. 6/13/97
A172/A199 3-14 SM
To Next Page
Loading...
