+
CAUTION
1. As the fusing unit may be hot, be careful when handling it.
2. Take care not to spill silicone oil on the floor. If silicone oil spills on
the floor, immediately clean it with a silicone oil remover. Silicone
oil is very slippery and can cause someone to slip and fall.
27. While releasing the lever [A], pull out the fusing unit [B].
28. Open the exit unit [C] (2 "D4" release levers).
29. Loosen the 2 black screws [D] until they moves freely so that the fusing
pressure is being applied.
NOTE:
Do not turn the pressure adjustment screws which are located
just beside the screws [D].
[A]
[B]
[C]
[D]
Installation
SM 3-15 A172/A199
To Next Page
Loading...
