30. Remove the fusing handle cover [A] (2 screws) and the fusing top cover
[B] (1 screw).
31. Prime the oil supply pad with silicone oil [C].
32. Remove the oil cap [D] and fill the tank with silicone oil to its max level [E].
33. Manually operate the oil pump lever [F] and confirm the proper operation
of the silicon oil supply system [G].
34. Reset the covers, the exit unit, oil cap and the fusing unit.
35. For
-26 and -27
machines, perform the following language ROM
installation procedures. For
-22
machines, perform if replacement to a
language other than English is needed.
1) Detach the operation panel [H] (2 screws). (Do not remove any
connectors.) Gently place it face down on the platen cover.
2) Remove the securing bracket [I] (2 screws).
3) Install the requested language rom board [J] using the securing
bracket and the accessory screw [K] as shown.
4) Reinstall the operation panel, making sure that the panel is properly
hooked in [L].
[J]
[K]
[I]
[L]
[H]
[A]
[B]
[C]
[D]
[E]
[F]
[G]
A172/A199 3-16 SM
To Next Page
Loading...
