4. Install two stepped screws [A].
5. Attach the sponge retainer [B] to the top cover of the copier as shown.
6. Mount the DF on the copier by inserting the two stepped screws into the
holes in the DF hinge [C], then slide the DF to the front, as shown.
7. Secure the DF to the copier by using the screw holes as shown
(2 screws - M5 x 10 [D]).
8. Remove the small cap on the upper rear cover then connect the main
connector [E] and the fiber optic cable connector [F].
[B]
[C]
[A]
[F]
[D]
[E]
Installation
SM 3-35 A172/A199
To Next Page
Loading...
