9. Secure the hinge stopper bracket [A] as shown (2 screws - M4 x 6).
10. Attach the feed-out guide mylar [B] under the original table. Attach it
between the 3rd [C] and 4th [D] ribs (counting from the rear).
11. Apply the appropriate decal at [E].
12. Remove the small cover [F] at the rear of the DF upper cover (1 screw),
and turn on DIP SW101-1.
13. Plug in the copier and turn on the main switch.
NOTE:
The copier automatically recognizes that the DF has been
installed.
14. Make copies using the DF and confirm the machine functions properly.
15. Explain to the customer that settings may now be changed, depending on
the characteristics of each original.
[A]
A610I507.wmf
[B]
[C]
[D]
[E]
[F]
Face up
Mit der Schriftseite
nach oben
Face imprimée
deuuus
Faccia in su
Boca arriba
A172/A199 3-36 SM
To Next Page
Loading...
