10. Remove the lamp cover [A] (1 screw) and open the reflector cover [B].
Then, plug the projector lamp [C] into the socket. Then close the reflector
cover.
NOTE:
The projector lamp should be inserted horizontally until it stops.
11. Remove the cap [D] from the upper right cover of the copier.
12. Run the optical fiber cable [E] between the projector control board (CN6)
and the copier through the rubber bushing [F] as shown.
13. Connect the power cord [G] to the power inlet and plug it into the wall
outlet.
+
WARNING
After plugging the power cord into the wall outlet, do not touch the
electrical components inside the projector unit other than the test
switch used in steps 14-4) and -8). Otherwise, you might receive an
electrical shock.
-
[A]
[C]
[B]
[G]
-
[E]
[F]
[D]
Installation
SM 3-47 A172/A199
To Next Page
Loading...
