15. Adjust the angle [A] of the mirror unit as follows:
1) Turn on the copier main switch and wait for the ready condition.
2) Open the lens cover and position the mirror unit on the exposure glass.
3) Put the correction filter [B] for positive films in the filter slot.
4) Turn on the projector main switch and press the option key.
5) Perform shading using the positive 35 mm slides mode.
6) Put one of the orange base films in the slide holder and position it in
the projector unit.
7) Make a copy of the orange film.
8) Check if the orange image is even or not. If the image is uneven,
adjust the mirror angle as follows:
8-1) When the leading part is dark [C].
a) Move the front and rear arm guides [D] to the left so that the
mirror angle is increased (2 screws each).
NOTE:
Position the arm guides at the same location at front
and rear, using the ruler decals. This prevents the mirror
from being twisted.
b) Make a copy of the orange film.
c) Repeat steps a) and b) until the orange image becomes even.
[A]
[B]
[D]
[C]
A172/A199 3-50 SM
To Next Page
Loading...
