11. Remove the developer supply funnel, then install the toner supply
receptacle.
12. Install the cyan, magenta and yellow developer in the same manner as
black developer installation (step #3 to #11).
NOTE:
To select the "color development drive motor ON" mode, enter
"69" for color instead of 68 for black (refer to step #7).
13. Return the developer supply funnel to the original position.
14. Touch the Previous key [A] to open page 3.
15. Perform the developer initial setting as follows.
1) Confirm that the main charge corona, PCC, ID sensor boards are
installed correctly (1 screw each).
2) Confirm that the toner tank is not installed.
NOTE:
If the toner tank is installed, toner is supplied during the
developer initial setting and the machine cannot figure out the
proper toner concentration of the new developer.
3) Touch the All Start key [B] to start the developer initial setting. After
the adjustment is completed, the machine stops automatically.
16. Touch the Index key [C].
[A]
[C]
[B]
A172/A199 5-16 SM
To Next Page
Loading...
