Bit Switches - 1
SM 81 D418
Fax Option
Type 9001
D418
System Switch 1E (SP No. 1-101-031)
No Function Comments
3
File No. printing
0: Enabled
1: Disabled
1: File numbers are not printed on any reports.
4
Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
yet programmed
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
If authorized reception is enabled but the user
has stored no acceptable sender RTIs or CSIs,
the machine will not be able to receive any fax
messages.
If the customer wishes to receive messages
from any sender that includes an RTI or CSI,
and to block messages from senders that do
not include an RTI or CSI, change this bit to
"1", then enable Authorized Reception.
Otherwise, keep this bit at "0 (default setting)".
5-7 Not used Do not change the settings
System Switch 1F (SP No. 1-101-032)
No Function Comments
0 Not used Do not change the settings.
1
Report printout after an original
jam during SAF storage or if the
SAF memory fills up
0: Enabled
1: Disabled
0: When an original jams, or the SAF memory
overflows during scanning, a report will be
printed.
Change this bit to "1" if the customer does not
want to have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
2 Not used Do not change the settings.
3
Received fax print start timing
(G3 reception)
0: The machine prints each page immediately
after the machine receives it.
To Next Page
Loading...
Need help?
General
