Bit Switches - 2
SM 83 D418
Fax Option
Type 9001
D418
4.4 BIT SWITCHES - 2
Do not adjust a bit switch or use a setting that is described as "Not used", as this
may cause the machine to malfunction or to operate in a manner that is not
accepted by local regulations. Such bits are for use only in other areas, such as
Japan.
Default settings for bit switches are not listed in this manual. Refer to the System
Parameter List printed by the machine.
4.4.1 I-FAX SWITCHES
I-fax Switch 00 (SP No. 1-102-001)
No Function Comments
Original Width of TX Attachment File
This setting sets the maximum size of the
original that the destination can receive. (Bits
3~7 are reserved for future use or not used.)
0 A4
1 B4
2 A3
3-6 Reserved
7 Not used
0: Off (not selected), 1: On (selected)
If more than one of these three bits is set to "1",
the larger size has priority. For example, if both
Bit 2 and Bit 1 are set to "1" then the maximum
size is "A3" (Bit 2).
When mail is sent, there is no negotiation with
the receiving machine at the destination, so the
sending machine cannot make a selection for
the receiving capabilities (original width setting)
of the receiving machine. The original width
selected with this switch is used as the RX
machine's original width setting, and the
original is reduced to this size before sending.
The default is A4.
If the width selected with this switch is higher
than the receiving machine can accept, the
machine detects this and this causes an error.
To Next Page
Loading...
Need help?
General
