Bit Switches - 5
D418 122 SM
4.7 BIT SWITCHES - 5
Do not adjust a bit switch or use a setting that is described as "Not used", as this
may cause the machine to malfunction or to operate in a manner that is not
accepted by local regulations. Such bits are for use only in other areas, such as
Japan.
Default settings for bit switches are not listed in this manual. Refer to the System
Parameter List printed by the machine.
4.7.1 G3-2 AND G3-3 SWITCHES
These switches require an optional G3 interface unit.
G3-2 and -3 switches are the same as for G3-1 switches.
4.7.2 G4 INTERNAL SWITCHES
The G4 internal switches (SW00 to 1F) are displayed but do not change these settings.
4.7.3 G4 PARAMETER SWITCHES
The G4 parameter switches (SW00 to 0F) are displayed but do not change these settings.
To Next Page
Loading...
Need help?
General
