Service Program Mode Tables
D062/D063/D065/D066 4-44 SM Appendix
4014* Scan
001 Execute 1 scan with HP detection On.
DF Dust Check
4020
This feature checks the ADF exposure glass for dust that can cause black lines
in copies. If dust is detected, a message is displayed, but the process does not
stop.
Dust Detect: On/Off: Front
001
Issues a warning if there is dust on the narrow scanning glass of the ADF when
the original size is detected before a job starts. This function can detect dust on
the white plate above the scanning glass, as well as dust on the glass. Sensitivity
of the level of detection is adjusted with SP4020-002.
[0 to 1/1]
0: Off. No dust warning.
1: On. Dust warning. This warning does not stop the job.
Note: Before switching this setting on, clean the ADF scanning glass and the
white plate above the scanning glass.
Detect Level: Front
002
Adjusts the sensitivity for dust detection on the ADF scanning glass. This SP is
available only after SP4020-001 is switched on.
[0 to 8/1]
If you see black streaks in copies when no warning has been issued, raise
the setting to increase the level of sensitivity.
If warnings are issued when you see no black streaks in copies, lower the
setting.
Dust that triggers a warning could move be removed from the glass by the
originals in the feed path. If the dust is removed by passing originals, this is
not detected and the warning remains on.
Correction Level: Front
003
Sets the level for vertical line correction (the black vertical lines caused by dust
on the ADF exposure glass).
To Next Page
Loading...
Need help?
General
