*1 You do not need to use the auxiliary side fence when loading B4 paper.
Change the position of the auxiliary side fence in the back in the same way.
4. While pressing the release lever of the end fence, slide the end fence outward.
If the end fence is fixed with the stopper, rotate the fixing screw of the stopper 90 degrees
counterclockwise with a coin or similar object and remove the stopper.
5. Square the paper and load it with the print side facing up.
Fan sheets before loading so that multiple sheets of paper do not stick to each other and are not
fed at once.
Do not stack paper over the limit mark.
8. Adding Paper and Toner
182
To Next Page
Loading...
