Sound pattern
*1
Condition Solution
Five long beeps [Auto Reset] The machine has been reset to the
default state after the specified period
of time has passed with the machine
unoperated. If you were performing
and paused an operation, perform
the operation from the beginning
again.
Five long beeps
(repeating four times)
[Sound of Less Urgent Level] Check that an original is not left on
the exposure glass and that paper is
loaded in the paper tray.
Five short beeps
(repeating five times)
[Sound of Urgent Level] Check the message displayed on the
screen, and resolve the problem by
removing the jammed paper or
original, or replacing the toner.
12 short beeps [Blank Page Detected] Check that the original is placed in
the ADF with the side to scan facing
up.
*1
The factory default sound pattern is used as an example in the table above.
• You cannot pause an alert sound that has started. The machine continues to emit the sound until the
preset sound pattern is completed.
• You can specify the volume and type of alert sound in [Settings] [Screen Features Settings]
[Sound]. The type of sound can be specified for each condition described in the table above. You
can also specify the volume of the sound emitted when using On-hook or Immediate Transmission
to send a fax in [Settings] [Machine Features Settings] [Fax Settings] [General Features]
tab [Adjust Sound Volume]. Press [Home] ( ) after specifying the settings.
• See "Setting the Sound Volume and Type", User Guide (Full Version).
9. Troubleshooting
224
To Next Page
Loading...
