When you set a 2-sided original in the One-pass duplex scanning ADF, the top right corner of the
original will be the base point for the enlargement/reduction of the reverse side. To enlarge or
reduce from the same point, set the original on the exposure glass and perform 2-sided copy.
3. Press [Copy Ratio] and select a copy ratio or size.
To specify a copy ratio or size other than the displayed setting, press [Others] and perform the
following procedure.
Specifying a copy ratio (Zoom/Reduce/Enlarge)
Enter a value or select the copy ratio.
Specifying a size (Size Magnification)
Press [Specify Copy Size] and enter the length of the original and copied image.
4. Press [Start].
• You can change the options of the copy ratio that is displayed on the Copy screen when pressing
[Copy Ratio]. You can also change the enlargement and reduction ratios that appear when [Copy
Ratio] [Others] is pressed on the Copy screen.
Making Enlarged or Reduced Copies
71
To Next Page
Loading...
