• Straighten curled or warped paper before loading.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease or the paper may
misfeed.
• When loading paper on a tray which has a few sheets of paper, multiple sheets of paper may be
fed at once from the tray. Take out all sheets, fan the sheets, and then load them again.
• You may hear the sound of rubbing paper. This is not a malfunction.
• Skew is the phenomenon when images are printed slantwise. If the paper skews, take out the stack
of paper, turn it over, and then load it again.
• If the paper still skews, take out the stack of paper, turn it around, and then load it again.
Loading Paper into Tray 1
• Slide the side fences until they are aligned with the sides of the paper. If there is space between the
side fences and the paper, it may cause the image to be misaligned.
7. Adding Paper and Toner
150
To Next Page
Loading...
