Ricoh IM C530 Series - Basic Procedure for Performing Send to Folder

Basic Procedure for Performing Send to Folder
1. Press [Scanner] on the Home screen.
2. Select [To Folder] on the scanner screen.
D0CSPA5908
3. Place the original on the scanner.
See "Placing an Original to Scan", User Guide (Full Version).
4. Press [Send Settings] and configure the scan settings according to the purpose of the
scanned data.
page 138 "Scanning an Original with Suitable Quality and Density"
page 140 "Specifying the File Type When Scanning a Document"
5. Press , select [Search Address Book] or [Specify by Reg. No.] and then specify the
shared folder that is registered in the address book.
D0CSPA5909
• To enter the information manually, press , and select [Manual Entry]. Select SMB as the
protocol and enter the required information.
• To specify the destination again, press .
6. Press [Start].
5. Scan
136