Ricoh IM C530 Series - Enlarging or Reducing According to the Paper Size

When you place 2-sided originals in the ADF, the top right corner of the original will be the base
point for the enlargement/reduction of the reverse side. To enlarge or reduce from the same point,
set the original on the exposure glass and perform 2-sided copy.
3. Press [Copy Ratio] and select a copy ratio or size.
To specify a copy ratio or size other than the displayed setting, press [Others] and perform the
following procedure.
Specifying a copy ratio (Zoom/Reduce/Enlarge)
Enter a value or select the copy ratio.
D0CSPA5501
Specifying a size (Size Magnification)
Press [Specify Copy Size] and enter the length of the original and copied image.
4. Press [Start].
• You can change the options of the copy ratio that is displayed on the Copy screen when pressing
[Copy Ratio]. You can also change the enlargement and reduction ratios that appear when [Copy
Ratio] [Others] is pressed on the Copy screen.
• See "Reduce / Enlarge", User Guide (Full Version).
Enlarging or Reducing According to the Paper Size
The original is enlarged or reduced to fit on the specified paper size (Scale to Paper Size)
Making Enlarged or Reduced Copies
57