"Problems with the
wireless board."
"Please call
service."
The wireless LAN
board can be
accessed, but an
error has been
detected.
Turn off the power of the machine, check
that the wireless LAN board is correctly
installed in the machine, and then turn on
the power.
page19”Turning On and Off the Power”
If the message persists even after you
have turned the power off and then on,
consider repairing the machine.
"Stopped Due to
High Voltage"
"Operation has
stopped due to high
voltage at the
power supply from
the wall outlet. Turn
the main power
switch off then on.
If this screen
appears again, turn
the main power off,
disconnect the
power cord, and
then call for
service."
Power supply
voltage is high.
Turn off the power of the machine, wait
for 10 seconds or more after confirming
that the main power indicator is turned
off, and then turn on the power.
page19”Turning On and Off the Power”
If the message persists even after you
have turned the power off and then on,
turn off the power of the machine, and
then disconnect the power cord plug from
the wall outlet before you contact your
service representative.
See "Installation Requirements After
Moving the Machine", User Guide (HTML).
"Updating the
destination list...
Please wait.
Specified
destination(s) or
sender's name has
been cleared."
A destination is
being registered
using Web Image
Monitor.
Wait until the message disappears and do
not turn off the power of the machine. You
may not be able to perform operations for
a while depending on the number of
destinations being registered.
"Updating the
destination list has
failed. Try again?"
A network error
occurred.
Check the connection between the
machine and the computer.
Anti-virus software
or a firewall
function is running
on the computer.
Add the destination list program to the
exception list in the anti-virus software on
the computer, or register the machine IP
address to the exception list in the firewall
function. You can check the IP address in
[Check Status] "Network".
To Next Page
Loading...
