Message Cause Solution
"Following output tray is full.
Remove paper."
The output tray is full. Remove paper from the output tray to
resume printing. Press [Continue] on the
display panel to resume printing.
"Internal cooling fan is
active."
Large print runs will cause
the machine's interior to
heat up, triggering the
cooling fan.
The fan will emit noise, but this is normal
and the machine will be operable while
the fan is running.
The amount of paper that can be
printed and the total operation time until
the fan starts running depends on the
temperature of the location at which the
machine is installed.
For people using IM 430Fb
If this message appears frequently, dust
may have accumulated in the
ventilation holes of the printer. Check
the vents, and clean the dust off. For
details, see "Cleaning the Ventilation
Holes", Maintenance.
For people using IM 350F, IM 350, or
IM 430F
If this message appears frequently,
contact your service representative.
"Printing was stopped due to
the power supply being low
voltage. Turn the main
power switch off then on."
Printing has stopped
because the power supply
voltage is low.
Turn off the power, and then turn it on
again.
"Self checking..." The machine is performing
image adjustment
operations.
The machine may perform periodic
maintenance during operations. The
frequency and duration of maintenance
depends on the humidity, temperature,
and printing factors such as number of
prints, paper size, and paper type.
Wait for the machine to resume
operation.
9. Troubleshooting
260
To Next Page
Loading...
