SERVICE PROGRAM MODE 1 March, 2000
4-32
36: 2-304 to 2-306 (User Stamp Size, Density, and Position)
These settings are the same as SP 2-301 to 2-303, except that they are for the
user stamp. User stamps are stored using user tool 5-8.
User tool 5-7 (SP 3-130 to 138) can be used to adjust the co-ordinates of types 0
to 8.
37: 2-308 (Date Stamp Position)
0: Upper left (horizontal), 1: Lower right (horizontal), 2: Lower left (vertical),
3: Upper right (vertical)
38: 2-309 (Page Numbering Type)
0: P1, P2, P3, . . 1: 1/5, 2/5, 3/5, . . 2: - 1 -, - 2 -, - 3 -, . . .
39: 2-310 (Default Page Number Stamping Position)
0: Upper right (horizontal), 1: Upper left (vertical), 2: Bottom middle (horizontal),
3: Center right (vertical)
Settings 0 and 1 determine the default for the ‘P1, P2’ and ‘1/5, 2/5’ types of page
numbering.
Settings 2 and 3 determine the default for the ‘- 1 -, - 2 -‘ types of page numbering.
40: 2-390 (Drum Size – A3 or DLT)
This setting changes the master making area. It also affects the available range for
the default image position shift (top/bottom, SP2-020-7).
A3: -15 mm to + 15 mm
DLT: -10 mm to + 10 mm
41: 2-400, 401 (Paper types for User 1 and User 2)
The user can customize two paper types (User 1 and User 2) in addition to the
three usual paper types (Normal, Thick, Special).
These SP modes give the machine a rough idea of what type of paper the user is
using as types User 1 and User 2.
0: This paper type is not being used at present
1: Standard, no feed (Standard paper type, non feed likely)
2: Standard, double feed (Standard paper type, double feed likely)
3: Thick, no feed (Thick paper type, non feed likely)
4: Thick, double feed (Thick paper type, double feed likely)
5: Thick, medium (Thick paper type, with intermediate chances of double and non-
feed)
To Next Page
Loading...
