1 March, 2000 SERVICE PROGRAM MODE
4-31
Service
Tables
28: 2-270 (Print Restart in Class)
This determines how the machine behaves if the Job Separator feature is not used.
1: Auto Start – After printing for one class has been finished, there is a pause of a
few seconds, then printing for the next class begins automatically. The short break
allows the user to take the stack of prints off the delivery table.
2: Disabled (Default) – After printing for one class has been finished, the machine
stops. The user must press Print to start printing for the next class.
29: 2-280 (
Paper Tray Priority
)
0: Tray 1, 1: Tray 2, 2: Paper feed table
30:
2-281 (Tray Mode Select)
0: Only trays 1 and 2 will be used for the auto select feature (this is known as ‘two-
tray mode’.
1: The paper feed table will be used for the auto select feature, as well as trays 1
and 2 (this is known as ‘three-tray mode’.
This SP mode is only used if Tray Auto Select is turned on (SP 2-282).
31: 2-291 (Restricted Access)
When the key counter is installed, the technician enables the key counter with SP
2-002. However, the user can override this setting with SP 2-291 (which is also
user tool 6-8).
OFF: Copies can be made even if the user has no key counter, regardless of SP 2-
002.
ON: The user must have a key counter, if SP2-002 has been switched on.
The default is OFF, so to use the key counter, the user must switch 2-291 on using
the equivalent user tool (6-8).
32: 2-300 (Stamp type)
This determines what the Stamping function (Stamp key) puts on the printouts.
33: 2-301 (Default stamp size)
This determines the size of the stamp.
0: Normal (about 32 x 64 mm), 1: x 2, 2: x 4, 3: x 8
34: 2-302 (Default Stamp Density)
0: Solid fill (default), 1: Fine pattern, 2: Coarse pattern
35: 2-303 (Default Stamp Position)
0: Upper left, 1: Upper middle, 2: Upper right, 3: Center left, 4: Center,
5: Center right, 6: Lower left, 7: Lower middle, 8: Lower right,
9: Everywhere (repeated)
User tool 5-4 (SP 3-120 to 128) can be used to adjust the co-ordinates of types 0
to 8.
To Next Page
Loading...
