20 February, 2001 USING SERVICE PROGRAM MODES
5-25
Service
Tables
6
Mode Number/Name Function/[Setting]
ADF/Printer Free Run910
Performs a free run for the ADF and printer using a
special ROM.
[0 = No / 1 = Yes] DFU
Binding Hole Range911*
Selects the diameter of the binding holes in the original
that the sensors will ignore. If set at “0”, this function is
disabled.
[0 ~ 20 / 12 / 1 mm/step]
Original jams may occur when feeding originals with
binding holes, because these holes may be detected by
the sensors. Use this SP to avoid this problem. For
example, setting this value to 12 mm will cause the
sensors to ignore binding holes up to 12 mm in diameter.
To Next Page
Loading...
