IMAGE TRANSFER 20 February, 2001
3-36
3.9 IMAGE TRANSFER
3.9.1 IMAGE TRANSFER ROLLER
1. Open the right door.
2. Pry open the plastic holders [A] at
each end of the roller, and lift off the
image transfer roller [B].
NOTE: 1) Leave the springs under
the roller in their original
position. When replacing
the roller, be sure that the
pegs [C] on the two
square black pieces [D]
are facing down into the
springs.
2) Do not touch the transfer
roller surface with bare
hands.
3.9.2 IMAGE DENSITY SENSOR
1. Open the right door.
2. Plastic cover [E]
3. Image transfer roller (☛ 3.9.1)
4. Push down on the notch [F] to free
the sensor.
5. Image density sensor [G] (" x 1)
B039R902.WMF
B039R931.WMF
[D]
[G]
[B]
[C]
[A]
[F]
[E]
To Next Page
Loading...
