Ricoh K-C1 - Registration Clutch

PAPER FEED SECTION 20 February, 2001
3-32
3.8.7 BY-PASS PAPER SIZE SWITCH
1. By-pass tray (☛ 3.3.13)
2. Tray lever [A] (! x 1, 1 pin)
3. Lift the upper tray [B]
4. By-pass paper size switch [C]
(" x 1)
NOTE: When reinstalling the switch:
Move the paper guides to
their middle position (about
halfway between fully open
and fully closed), and install
the round gear so that the
hole in the gear [D] aligns
with the peg [E] on the
sliding gear.
3.8.8 REGISTRATION CLUTCH
1. Rear cover (☛ 3.3.1)
2. Bracket holding the high-voltage power supply board [F] (" x 5, all connectors)
3. Registration clutch [G] (! x 1, # x 1)
B039R704.WMF
B039R909.WMF
B039R911.WMF
[E]
[D]
[C]
[A]
[B]
[F]
[G]