Ricoh K-C1 - Tray Heaters; Upper Tray Heater

TRAY HEATERS 20 February, 2001
1-22
1.11 TRAY HEATERS
1.11.1 UPPER TRAY HEATER
1. Remove the 1st tray cassette [A].
2. Remove the rear cover (☛ 3.3.1).
3. Remove the high voltage power supply board [B] with bracket (5 screws and 3
connectors).
4. Pass the connector [C] through the opening [D] and install the tray heater [E] (1
screw).
5. Install the relay cable [F], as shown.
6. Clamp the cable with the clamp [G].
7. Reinstall the 1st tray cassette, power pack, and rear cover.
B039I020.WMF
B039I909.WMF
B039I126.WMF
B039I121.WMF
[A]
[F]
[B]
[E]
[C]
[D]
[G]