20 February, 2001 COPIER INSTALLATION
1-7
Installation
11. Install the optional ARDF, ADF, or platen cover (☛ 1.3/1.4/1.5).
12. Plug in the main power cord and turn on the main switch. Perform TD Sensor
Initialization (SP2-214).
13. Select the correct display language using UP Mode (Language).
14. Load the paper in the paper tray and make a full size copy, and check if the
side-to-side and leading edge registrations are correct. If they are not, adjust
the registrations (☛ 3.13 Copy Adjustments: Printing/Scanning).
15. Initialize the electric total counter using SP7-825 in accordance with the type of
service contract.
NOTE: Select 1, then press the Original Type and OK keys at the same time. If
the reset is successful, “Action completed” will appear on the LCD.
To Next Page
Loading...
