ARDF INSTALLATION 20 February, 2001
1-10
2. Remove the left scale [A] (2
screws).
3. Place the DF exposure glass
[B] on the glass holder.
NOTE: When installing the DF
exposure glass, make
sure that the white
point [C] is face down.
4. Peel off the backing [D] of the
double-sided tape attached to
the rear side of the scale guide
[E], then install it (2 screws
removed in step 2).
5. Install the two stud screws [F].
6. Mount the DF on the copier,
then slide the DF to the front.
7. Secure the DF unit with two
screws [G].
8. Connect the cable [H] to the
copier.
9. Attach the appropriate scale
decal [I] as shown.
10. Turn the main power switch
on. Then check if the
document feeder works
properly.
11. Make a full size copy, and
check that the side-to-side and
leading edge registrations are
correct. If they are not, adjust
the side-to-side and leading
edge registrations. (☛ 3.13.3
ADF Image Adjustment)
B379I103.WMF
B379I104.WMF
B379I501.WMF
[F]
[A]
[F]
[B]
[C] [D]
[E]
[H]
[G]
[I]
To Next Page
Loading...
