Ricoh M C240FW - Setting Up the Printer to Fax

Set up, install, and configure 25
Setting up the printer to fax
Setting up the fax function using analog fax
Notes:
• This feature is available only in some printer models.
• Some connection methods are applicable only in some countries or regions.
• If the fax function is enabled and not fully set up, then the indicator light may blink red.
• If you do not have a TCP/IP environment, then use the control panel to set up fax.
Warning—Potential Damage: To avoid loss of data or printer malfunction, do not touch cables or the printer in
the area shown while actively sending or receiving a fax.
Using the fax setup wizard in the printer
Notes:
• The setup wizard is available only if no device-based fax, such as analog, or Fax over IP (FoIP), is configured.
• Before using the wizard, make sure that the printer firmware is updated. For more information, see Updating
firmware.
1 From the home screen, touch Fax.
2 Touch Set up now.
3 Type the fax name, and then touch Next.
4 Enter the fax number and then touch Done.
Using the Settings menu in the printer
1 From the home screen, touch Settings > Fax > Fax Setup > General Fax settings.
2 Configure the settings.