Ricoh MP C305SPF User Manual

Error Codes
D649 20 SM
Code Meaning Suggested Cause/Action
0-04
CFR or FTT not received
after modem training
 Check the line connection.
 Try changing the tx level and/or cable
equalizer settings.
 Replace the FCU.
 The other terminal may be faulty; try sending
to another machine.
 If the rx signal is weak or defective, there may
be a bad line.
Cross reference
Tx level - NCU Parameter 01 (PSTN)
Cable equalizer - G3 Switch 07 (PSTN)
Dedicated Tx parameters in Service Program
Mode
0-05
Modem training fails even
G3 shifts down to 2400
bps.
 Check the line connection.
 Try adjusting the tx level and/or cable
equalizer.
 Replace the FCU.
 Check for line problems.
Cross reference
See error code 0-04.
0-06
The other terminal did not
reply to DCS
 Check the line connection.
 Try adjusting the tx level and/or cable
equalizer settings.
 Replace the FCU.
 The other end may be defective or
incompatible; try sending to another machine.
 Check for line problems.
Cross reference
See error code 0-04.

Ricoh MP C305SPF Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Scan Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
ADF Capacity	50 sheets
Duplex Printing	Yes
Connectivity	USB 2.0, Ethernet 10/100Base-TX
Functions	Print, Copy, Scan, Fax
Scanner Type	Flatbed, ADF
Fax Speed	33.6 Kbps
Print Speed	30 ppm
Paper Capacity	350 sheets
Paper Size	A4, A5, A6, B5
Fax Transmission Speed	Approximately 3 seconds per page
Operating System Compatibility	Windows, Mac, Linux