Ricoh MP C305SPF User Manual

Process Control Error Conditions
SM 6-77 D117/D118
Troubleshooti
ng
6.2.2 PROCESS CONTROL SELF-CHECK RESULT
Displayed number shows results of each color sensor check.
00000000 = YYCCMMKK
SP3-012-001 to -010 (Process Control Self-check Result)
No. Result Description Possible Causes/Action
11
Successfully
completed
Process control
self-check
successfully
completed.
Check the Vsg adjustment. See the "Vsg
Adjustment Result" following this table.
41 Vt error
Vt maximum or
minimum error is
detected.
 Defective development unit
Vt maximum error and an image is faint:
1. Replace the toner supply pump unit.
Vt maximum error and an image is O.K:
1. Replace the development unit.
2. Replace the BICU board.
Vt minimum error:
1. Replace the development unit.
2. Replace the BICU board.
53
ID sensor
coefficient
(K5) detection
error
Not enough data can
be sampled.
 Solid image is not sufficient density:
1. Retry the process control.
2. Replace the ID sensors.
3. Replace the BICU board.
 Solid image is O.K.
1. Replace the ID sensors.
2. Replace the BICU board.
 ID sensor is dirty:
1. Clean the ID sensors.
2. Retry the process control.

Ricoh MP C305SPF Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Scan Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
ADF Capacity	50 sheets
Duplex Printing	Yes
Connectivity	USB 2.0, Ethernet 10/100Base-TX
Functions	Print, Copy, Scan, Fax
Scanner Type	Flatbed, ADF
Fax Speed	33.6 Kbps
Print Speed	30 ppm
Paper Capacity	350 sheets
Paper Size	A4, A5, A6, B5
Fax Transmission Speed	Approximately 3 seconds per page
Operating System Compatibility	Windows, Mac, Linux