Ricoh MP C305SPF User Manual

Process Control Error Conditions
SM 6-75 D117/D118
Troubleshooti
ng
6.2 PROCESS CONTROL ERROR CONDITIONS
6.2.1 DEVELOPER INITIALIZATION RESULT
SP-3-014-001 (Developer Initialization Result)
No. Result Description Possible Causes/Action
1
Successfully
completed
Developer
initialization is
successfully
completed.
-
2
Forced
termination
Developer
initialization was
forcibly terminated.
 A cover was opened or the main
switch was turned off during the
initialization.
1. Do the developer initialization again
when done in SP mode. Reinstall the
engine main firmware if the result is
the same.
2. Turn the main switch off and on when
done at unit replacement.
6 Vt error
Vt is more than 0.7V
when Vcnt is 4.3V.
1. Make sure that the heat seal on the
development unit is not removed.
2. Defective TD sensor
7 Vcnt error 1
Vcnt is less than 4.7V
when Vcnt is Vt target
±0.2V.
1. Defective TD sensor
2. Vt target settings are not correct.
3. Toner density error
8 Vcnt error 2
Vt is more than 0.7V
when Vcnt is 4.3V and
Vcnt is less than 4.7V
when Vcnt is Vt target
±0.2V.
1. Make sure that the heat seal on the
development unit is not removed.
2. Defective TD sensor

Ricoh MP C305SPF Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Scan Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
ADF Capacity	50 sheets
Duplex Printing	Yes
Connectivity	USB 2.0, Ethernet 10/100Base-TX
Functions	Print, Copy, Scan, Fax
Scanner Type	Flatbed, ADF
Fax Speed	33.6 Kbps
Print Speed	30 ppm
Paper Capacity	350 sheets
Paper Size	A4, A5, A6, B5
Fax Transmission Speed	Approximately 3 seconds per page
Operating System Compatibility	Windows, Mac, Linux