Controller Options
D117/D118 2-88 SM
 The place [C] on the cover is for storing the SMC list when the machine is shipped.
6. Reassemble the machine.
 The original application SD card should be kept in a safe place, for the following reasons:
 The SD card can be the only proof that the user is licensed to use the application
program.
 You may need to check the SD card and its data to solve a problem in the future.
Move Exec
The menu "Move Exec" (SP5-873-001) lets you move application programs from the original SD
card to another SD card.
 Do not turn ON the write protect switch of the system SD card or application SD card on
the machine. If the write protect switch is ON, a download error (e.g. Error Code 44)
occurs during a firmware upgrade or application merge.
1. Turn the main switch off.
2. Make sure that a target SD card is in SD Card Slot 1 (upper). The application program is
moved to this SD card.
3. Insert the source SD card with the application program in SD Card Slot 2 (lower).The
application program is copied from this source SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-001 "Move Exec".
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the source SD card from SD Card Slot 2 (lower).
10. Turn the main switch on.
11. Check that the application programs run normally.
To Next Page
Loading...
Need help?
General
