Interface Settings
51
2
❖ Ping Command
Check the network connection with ping command using given IPv4 address.
If you fail to connect to the network, check the following, and then retry the
ping command.
• Make sure that "IPv4" in [Effective Protocol] is set to "Active".
• Check that the machine with assigned IPv4 address is connected to the net-
work.
• Check if the same IPv4 address is used for the specified equipment.
❖ Permit SNMPv3 Communictn.
Set the encrypted communication of SNMPv3.
The default setting is Encryption/Clear Text.
If you select to [Encryption Only], you need to set an encryption password for
the machine.
❖ Permit SSL/TLS Comm.
Set the encrypted communication of SSL/TLS.
The default setting is Ciphertext/Clear Text.
If you set to [Ciphertext Only], you need to install the SSL certificate for the ma-
chine.
❖ Host Name
Specify the host name.
Enter the host name using up to 63 characters.
❖ Machine Name
Specify the machine name.
Enter the machine name using up to 31 characters.
Reference
p.4 “Accessing User Tools”
"Settings You Can Change With User Tools", Network Guide
To Next Page
Loading...
