Ricoh MP161SPF - Reproduction Ratio

Copier Features
83
3
❖ Original Count Display
You can set to display the count of originals and copying pages on the display
when [On] is selected.
The default setting is Off.
❖ Reproduction Ratio
You can select which reduce, enlarge, or input ratio is shown on the display
with priority when [Reduce] or [Enlarge] is selected.
Reduce or Enlarge ratios for setting are as follows:
The default setting for "Ratio 1" is 50% (Metric version) / 65% (Inch version).
The default setting for "Ratio 2" is 71% (Metric version) / 78% (Inch version).
The default setting for "Ratio 3" is 93% (Metric version) / 93% (Inch version).
The default setting for "Ratio 4" is 141% (Metric version) / 129% (Inch ver-
sion).
The default setting for "Ratio 5" is 200% (Metric version) / 155% (Inch ver-
sion).
You can set a ratio other than the above.
A Select [Reproduction Ratio] using {U} or {T}, and then press the {OK} key.
B Select the ratio you want change using {U} or {T}, and then press the {OK}
key.
C Select [User R/E Ratio] using {U} or {T}, and then press the {OK} key.
D Enter a ratio using the number keys from "50-200", and then press the {OK}
key.
The “programmed” message appears.
❖ Preset R/E Priority
You can set the ratio with priority when [R/E] is selected.
Using the number keys, enter the ratio from "50-200" in units of 1%.
The default setting is 71% (Metric version) / 65% (Inch version).
❖ Duplex Margin
Specify left margin on the back side of copies, and top margin on the front
side. Select [Top Margin] or [Left Margin], and then set the required value.
• Top Margin: 0-50mm, 0"-2.0"
• Left Margin: 0-50mm, 0"-2.0"
The default setting is 5 mm (Metric version) / 0.2 inch (Inch version).