Message Problem and solutions
TRAP. Specify the host IPX address for the TRAP
destination.
add_sess_ipx: community <communityname>
already defined.
The same community name already exists. Use
another community name.
adjust time server <NTP server name> offset: xx sec. ncsd tells you the timing of the NTP server and
whether or not the time system clock is set.
NTP Server: NTP server name
offset: number of seconds of delay (minus number
if a time in advance is specified)
authenticated The supplicant is authenticated.
authenticating The supplicant is authenticating with the access
point (EAP or WPA).
Authentication mode mismatch The authentication mode of the access point is
different from the authentication mode of the
supplicant.
Use the authentication mode between the access
point and the supplicant.
Client EAP method rejected The authentication mode of the access point is
different with the authentication mode of the
supplicant.
Use the same authentication mode between the
access point and the supplicant.
Client password rejected The client's password was rejected. Check the client
password.
Client TLS certificate rejected The client's TLS certificate was rejected. Check the
certificate.
cipher suite mismatch The uni-cast / multi-cast suite (TKIP/AES/WEP) of
the access point is different from the suite used by
the supplicant.
connecting The supplicant is waiting for wireless connection to
the access point.
2. Monitoring and Configuring the Printer
124
To Next Page
Loading...
