Message Problem and solutions
Current Interface Speed: xxxMbps Speed of the network (10Mbps, 100 Mbps, or
1Gbps).
Duplicate IP = <IP address> (from <MAC
address>).
The same IP address (IPv4, or IPv6 address) was
used. Each IP address (IPv4, or IPv6 address) must
be unique. Check the address of the device
indicated in [MAC address].
IEEE 802.11 Card does NOT support WPA . A wireless card that does not support WPA is
installed. Install a wireless card that supports WPA.
IEEE 802.11 Card Firmware REV.<version> Displays the version number of the 802.11 card's
firmware.
IEEE 802.11 card removed The wireless card managed by the supplicant has
been removed.
IEEE 802.11 current channel <channel nember> Displays the current channel number of the active
wireless card (in ad hoc and infrastructure mode).
IEEE 802.11 interface down The IEEE 802.11 interface managed by the
supplicant is disabled, or cannot connect to the
access point.
IEEE 802.11 interface up The IEEE 802.11 interface managed by the
supplicant is enabled, or is connected to the access
point.
IEEE 802.11 MAC Address = <MAC address> Displays the MAC address of the wireless interface.
IEEE 802.11 SSID <ssid> (AP MAC Address
<MAC address>)
The MAC address and SSID of the access point are
connected in infrastructure mode.
IEEE 802.11 <communication mode> mode Displays IEEE 802.11 communication mode.
inetd start. The inetd service has started.
Interface (interface name): Duplicate IP Address
(<IP address>).
The same IP (IPv4 or IPv6) address was used. Each
IP address must be unique. Check the address of
the device indicated in [IP address].
< Interface > started with IP: < IP address > IP address (IPv4 or IPv6 address) has been set for
the interface and is operating.
Message List
125
To Next Page
Loading...
