Message Problem and solutions
< Interface >: Subnet overlap. The same IP address (IPv4, orIPv6 address) and the
subnet mask is used with other device.
LEAP challenge to access point failed The LEAP challenge to the access point has failed.
MIC failure TKIP counter measures started The supplicant using TKIP has detected two
instances of tampering within 60 seconds and has
started counter measures.
MIC failure TKIP counter measures stopped Counter measures have stopped after 60 seconds
(since the supplicant using TKIP started counter
measures against tampering).
no RADIUS/authentication server The supplicant has received a message reporting
that a usable RADIUS server cannot be found.
no smart card detected on device PEAP/GTC (Generic Token Card) is selected, but
a smart card using GTC authentication cannot be
found.
no WPA information element in probe response,
rescanning
There is no WPA information on the response from
the SSID probe of the access point you want to use.
The supplicant is rescanning.
server certificate invalid The server ID is disabled. Check the server
authentication.
server identity invalid The server ID is disabled. Check the server
authentication.
server not trusted The RADIUS server cannot be trusted.
session IPv4 <community name> not defined. The requested community name is not defined.
session IPv6 <community name> not defined. The requested community name is not defined.
session_ipx <community name> not defined. The requested community name is not defined.
shutdown signal received. network service
rebooting...
The smbd service has started.
SMTPC: failed to get smtp server ip-address. The SMTP server IP address could not be obtained.
This could be because:
• The specified DNS server could not be found.
2. Monitoring and Configuring the Printer
126
To Next Page
Loading...
