• For the bias during paper transfer at the start of printing, the machine performs constant voltage
control and then switches to constant current control. If you set "CV Start Timing" to "50ms" and "CV
Control Duration" to "30ms", constant voltage control for the paper transfer bias starts 50
milliseconds before printing a sheet and lasts for 30 milliseconds,. This is followed by constant
current control for the remaining 20 milliseconds, after which printing starts.
Setting Items Max. Value Min. Value Step Unit
[Ppr Trns CV: Start Timing: BW: Side 1] 100 0 1 ms
038: [Ppr Trns CV: Start Timing: BW: Side 2]
Adjust the timing to start constant voltage control for the bias on Side 2 during paper transfer when
printing in black-and-white mode.
Use this to adjust transferability at the leading edge of the paper.
Press [+] or [−] to adjust the start timing.
Setting Items Max. Value Min. Value Step Unit
[Ppr Trns CV: Start Timing: BW: Side 2] 100 0 1 ms
041: [Ppr Trns CV: Start Timing: FC: Side 1]
Adjust the timing to start constant voltage control for the bias on Side 1 during paper transfer when
printing in full color.
Use this to adjust transferability at the leading edge of the paper.
Press [+] or [−] to adjust the start timing.
Setting Items Max. Value Min. Value Step Unit
[Ppr Trns CV: Start Timing: FC: Side 1] 100 0 1 ms
042: [Ppr Trns CV: Start Timing: FC: Side 2]
Adjust the timing to start constant voltage control for the bias on Side 2 during paper transfer when
printing in full color.
Use this to adjust transferability at the leading edge of the paper.
Press [+] or [−] to adjust the start timing.
Setting Values
135
To Next Page
Loading...
