• Decreasing the temperature too much may cause the toner to not properly fuse to the paper. (cold
offset).
Setting Items Max. Value Min. Value Step Unit
[Fusing Pressure Roller Temp] 200 50 1 degree(s)
052: [Fusing Nip Width Setting]
Adjust the nip width between the fusing belt and pressure roller.
Press [+] to increase the nip width and [−] to reduce it.
• Changing this setting may lead to insufficient fusing, which may cause the toner to unfuse from the
paper (cold offset).
Setting Items Max. Value Min. Value Step Unit
[Fusing Nip Width Setting] 3 1 1 None
053: [Fusing Temp to Feed Ppr]
Adjust the fusing temperature at which to allow paper feeding after warming up.
Paper feeding starts when the fusing unit reaches the temperature defined by the selected mode. Select
one of the following modes:
1-3, 5, 6 This is the normal printing mode that is assigned according to the paper type.
4 To reduce problems with glossiness and fusing errors that may occur initially, this mode
allows the temperature of the machine to be brought to a stable fusing temperature before
printing starts.
Setting Items Max. Value Min. Value Step Unit
[Fusing Temp to Feed Ppr] 6 1 1 None
054: [Additional Fusing Temp 1]
Adjust the fusing unit's accumulated temperature for a specific time after a job starts.
4. Details of Menu Items in Advanced Settings
142
To Next Page
Loading...
