Depending on the operating environment, the fusing temperature may drop before paper is transferred
to the fusing unit. Use this function to prevent the fusing temperature dropping.
Fusing temperature must be adjusted if a fusing error or abnormal luster occurs after three to ten pages
of a multi-page job are printed.
Press [+] to increase the temperature and [−] to reduce it.
Setting Items Max. Value Min. Value Step Unit
[Additional Fusing Temp 1] 30 0 1 degree(s)
055: [Additional Fusing Temp 2]
Adjust the fusing unit's accumulated temperature for a specific time after writing starts.
Depending on the operating environment, the fusing temperature may drop before paper is transferred
to the fusing unit. Use this function to prevent the fusing temperature dropping.
Fusing temperature must be adjusted if a fusing error or abnormal luster occurs after three to ten pages
of a multi-page job are printed.
Press [+] to increase the temperature and [−] to reduce it.
Setting Items Max. Value Min. Value Step Unit
[Additional Fusing Temp 2] 30 0 1 degree(s)
056: [Cleaning Web Rotation Interval]
Specify the interval between each activation of the cleaning web.
If you set this to "-50%", the interval is reduced in half. Reducing the interval causes the cleaning web to
wear out twice as fast, which makes it necessary to replace the cleaning web more often.
Press [+] to increase the interval and [−] to reduce it.
Setting Items Max. Value Min. Value Step Unit
[Cleaning Web Rotation Interval] 0 -75 5 %
057: [Cleaning Web Contact Position]
Specify the cleaning web separation behavior during printing.
If set to [On], the cleaning web separates during printing. If paper jams or the fusing pressure roller
rotates in reverse, the cleaning web automatically separates regardless of this setting.
Setting Values
143
To Next Page
Loading...
