This must be adjusted if image quality degradation due to fusing (black spots) occurs when printing on
glossy or matte paper.
Setting Items Values
[Cleaning Web Contact Position] [On]
[Off]
058: [Fusing Nip Width Adjustment: Envelope]
Adjust the nip width between the fusing belt and pressure roller when an envelope is being fed. If the
envelope becomes wrinkled, press [−] to reduce the nip width. If a fusing error develops on the
envelope, press [+] to increase the nip width. Increasing the nip width too much may cause the envelope
to become wrinkled.
Setting Items Max. Value Min. Value Step Unit
[Fusing Nip Width Adjustment: Envelope] 20000 0 1 Micromete
r
059: [Fusing Nip Width: Envelope: Decompression]
Specify whether to wait for heat to accumulate before printing on an envelope at a high/normal
temperature.
If 5 is specified, the waiting time specified in 061: [Accumulate Heat Before Feeding Envelope] will be
inserted.
If a value between 1 and 4 is specified, no waiting time will be inserted, but fusing errors may occur.
Setting Items Max. Value Min. Value Step Unit
[Fusing Nip Width: Envelope:
Decompression]
5 1 1 -
060: [Fusing Nip Width: Envelope: Decompression: L Temp]
Specify whether to wait for heat to accumulate before printing on an envelope at a low temperature.
If 5 is specified, the waiting time specified in 061: [Accumulate Heat Before Feeding Envelope] will be
inserted.
If a value between 1 and 4 is specified, no waiting time will be inserted, but fusing errors may occur.
4. Details of Menu Items in Advanced Settings
144
To Next Page
Loading...
