Trigger Delay 0 ns to 85 s
Sweep Characteristics
Carrier
Waveforms
Sine, Square, Ramp, Arb (except DC)
Type Linear, Log or Step
Direction Up or Down
Start/Stop
Frequency
1 μHz to 250 MHz 1 μHz to 250 MHz 1 μHz to 100 MHz 1 μHz to 70 MHz
Sweep Time 1 ms to 300 s
Hold/Return
Time
0 ms to 300 s
Trigger Source Internal, External or Manual
Marker Falling edge of Sync signal (programmable)
Programming Time
Configuration Times (Typical)
USB2.0 LAN GPIB
Function Change 500ms 510ms 510ms
Frequency Change 50ms 50ms 50ms
Amplitude Change 300ms 310ms 310ms
Select User Arb 500ms 510ms 510ms
Arb Download Times (Binary Transfer)
1 Mpts/s
Note: Download times do not include setup or output time.
Trigger Characteristics
Trigger Input
Level TTL-compatible
Slope Rising or falling (selectable)
Pulse Width > 50 ns
Latency Sweep: <100 ns (typical)
Burst: <300 ns (typical)
Trigger Output
Level TTL-compatible
Pulse Width > 60 ns (typical)
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
