Rigol MSO5104 User Manual

RIGOL Chapter 20 System Utility Function Setting
20-2 MSO5000 User Guide
Remote Interface Configuration
MSO5000 series can communicate with the PC via the USB, LAN, or GPIB (requiring
to work with RIGOL's USB-GPIB interface converter) interface. Before using the
remote interfaces, configure the corresponding interface according to the
introductions in the following section.
LAN Configuration
Before using the LAN bus, use a network cable to connect the oscilloscope to your
local area network. The network interface of the oscilloscope is on the rear panel.
Press Utility → IO → LAN to open the LAN Settings interface, as shown in the
following figure. You can view the current network settings and configure the
network parameters.
Figure 20-1 Network Connection Setting Interface
Network Status
Different prompts will be displayed according to the current network connection
status.
⚫ Network Config Succeeded!
⚫ Acquiring IP...
⚫ IP Conflict!
⚫ Disconnected!
⚫ DHCP Config Failed!
⚫ Read Status Fail!
⚫ Connected!
Network Status
Current IP Config.
Type
MAC Address
VISA Descriptor
IP Config. Type
Network Parameters
Web Control

Rigol MSO5104 Specifications

General

Type	Tabletop
Product type	-
Bandwidth	100 MHz
Sampling rate	500000 MS/s
Channels quantity	16 channels
Minimum time base setting (per division)	3.5 ns
Display type	LCD
Display diagonal	9 \
AC input voltage	100 - 240 V
AC input frequency	45 - 440 Hz
Power consumption (max)	75 W
Non-operating altitude	3000 - 15000 m
Storage temperature (T-T)	-30 - 70 °C
Operating temperature (T-T)	0 - 50 °C

Weight and Dimensions

Width	367 mm