Robertson AP21 and AP22 Autopilots
86 20220596E
and if an attempt is made to access the AUTO or NAV modes
prior to completion of setup.
• The Dockside, Interface and Seatrial settings can only be
accessed when the system is in STBY mode.
• The values that are selected (also referred to as
"PARAMETERS") from within the Installation Settings Menu,
are stored in the memory of the autopilot system. No specific
action is required to "SAVE" the selected values. Once the
value is changed, it is stored until the next time the menu
item is selected and changed.
• The Installation Settings except for the language are
considered global, enabling values to be available to all
control units in the system.
• The values in the Seatrial Settings are dependent on
successful completion of the Dockside Settings.
Before attempting to turn on the autopilot and perform an
Installation Setup, the hardware installation and electrical
installation must be completed in accordance with the
installation instructions.
Installation Menu
The Installation Menu (IM) is presented on the autopilot display
by pressing and holding the NAV/SETUP push-button for 5
seconds. The below screen is the first display to be presented
when the IM is accessed.
English
INSTALLATION
Language
Note ! The INSTALLATION MENU is different from the USER SETUP
MENU . Refer to flow diagram on the next page for a pictorial view of
the Installation Menu.
To Next Page
Loading...