Robertson AP21 and AP22 Autopilots
88 20220596E
There are several actions that you can do once you have
accessed the IM:
• Answer YES to the question by rotating the course knob
clockwise.
• Change the highlighted item by rotating the course knob.
• Proceed to the next item in the menu by pressing the STBD
push-button. (Proceeding to the next item when presented
with a question is the same as answering NO to the
question.)
• Proceed back to the previous item in the menu by pressing
the PORT button.
• Leave the Installation Menu by selecting STBY, AUTO, or
NAV.
On new installations, and whenever a control unit, junction
unit, or software is replaced in the autopilot system, it is
recommended that a MASTER RESET be performed as
described in the IM prior to proceeding with the setup
procedure.
When using the Installation Menu refer to the "Installation
Menu" diagram on previous page.
Language selection
The autopilot can present the display in eight different
languages:
•
English, Deutsch, Francais, Espanol, Italiano, Nederlands,
Svenska and Norsk.
To access the language selection in the IM:
1. Select Language by pressing and holding the NAV/SETUP
push-button for 5 seconds.
English
INSTALLATION
Language
2. Turn the course knob to select the language you wish to use.
3. Leave the Installation Menu by a press on the STBY button,
or continue to next item in the menu by pressing STBD
button.
To Next Page
Loading...