Robopac ROBOT MASTER - Wrapping Modes

ENG
TECHNICAL INFORMATION
28
3.2.2. WRAPPING MODES
Single wrapping
It starts at the base of the pallet (with a series of
stabilising wrappings) and then stops at the top after
completing the final wrapping.
To start a new wrapping phase from the base, the spool
carriage must be lowered using the manual controls.
1)
START
2)
Stop
Double wrapping
It starts at the base of the pallet (with a series of
stabilising wrappings) up to the top side.
After performing a reinforcement wrapping at the top, the
wrapping process continues to the bottom and stops
after performing the final wrapping.
1)
START
Stop
Double wrapping with feeder
It starts at the base of the pallet (with a series of
stabilising wrappings) and then momentarily stops at the
top side.
After the protection sheet (
TOP
) has been added, the
operator resumes the wrapping cycle using the relevant
control.
After performing a reinforcement wrapping at the top, the
wrapping process continues to the bottom and stops
after performing the final wrapping.
1)
START
Stop
2)
START
Stop