Riskof Accident
WARNING
During maintenance, there isan increased risk of accident due to the parts, toolsand equipment
used in and around the Palletizing Solution area.
l
Slip, trip and fall hazards can be avoided by maintaining order and cleanliness in the workplace.
l
For work in elevated positions (500 mm and more), fall protection equipment must be installed and used.
l
When dismantling or replacing machine parts in elevated positions (500 mm and more), suitable lifting devicesshould be used.
Hot Surfaces
The proper use of the Palletizing Solution doesnot create hot surfaces. If surfacesget hot, investigate to see where the heat is
coming from.
Radiation
The proper use of the Palletizing Solution doesnot create non-ionizing radiation.
PneumaticLimitations
l
The maximum permissible pressure for all pneumatic componentsmust never be exceeded.
l
Pneumatic tubing must be checked at regular intervalsand replaced if necessary.
l
Leaky connections must be sealed to avoid breakage, unnecessary or excessive noise, loss of energy, etc.
Protective Devices
Manipulating or circumventing protective devicesduring the operation of the Solution isgenerally not permitted and should be
considered negligent.
WARNING
In the event of incorrectly installed, defective or even missing protective devices, operation of the
machine isnot permitted.
12
To Next Page
Loading...
