Roche Accutrend Plus - 7 Memory; Reviewing Results in Memory

Memory
63
English
7 Memory
The Accutrend Plus meter has four memory areas, each of which can be used to save up to 100
test results together with date, time and flags.
Reviewing results in memory
If you use the meter without setting the date or time, no time/date information will be saved
with the test results.
1 Power on the meter directly in memory
mode by pressing the M button, or by
pressing this button when the meter is in
coding mode.
You can exit memory mode by pressing
the On/Off button .
After the usual display test has been per-
formed when powering on the meter, the last
saved test result is displayed.
The icon mem appears in the display and indi-
cates that the meter is in memory mode. The
date and time on the display match the time at
which the measurement was performed, and
not the current time. In memory mode, the
colon between the hour and the minutes of
the time display does not flash.